Recent content by shado667

graphics the graphics are stationary....really no difference between test mode and play mode.

Yep..Firefox at home (mac) and at work (Pc). Really strange.

Nope...still can't see the pics. There's only two pics in your album from my end...both of the Frogger sound repair. Don't see anything with a cocktail. :(

Let me see what I can do...it won't be a problem to make two...just gotta find a corresponding piece for the new access panel that the security bar can fit through...Will check Home Depot and see what they have that can work....Bob Roberts had three security bars on his "junk page", but he...

Trickman...your pics didn't show...can you try re-uploading?

Looking forward to the pics...thanks for your help!

Thanks for the reply....I can easily make a new door, but I've never seen how the security bar fits into the thing (or what it looks like for that matter)... I'd really appreciate it if you could post some pics. Thanks!

EVB: I need to make one of these that's missing in a centipede cocktail I'm restoring. How does this thing mount/attach on the inside of the cocktail? I've never seen one before and could use some help.

I posted this in the "General Repair" forum and didn't get any response...hopefully someone here can help. I'm finishing up an Atari Centipede Cocktail. All that's left is touch up, but my big problem is that the previous owner got rid of the front access panel. I have no idea how this is...

Like the title says...The last part of my restoration is to replace the front access panel of a centipede cocktail. The cocktail I picked up had the original front panel missing. I've been looking for a while, but can't seem to find one anywhere so I figure I'll just make one myself. My...

bit_slicer....you and spyridon were both right. I replaced the LS157 but the problem persisted. Retraced my grounds and found that the control ground was in pin 15 of the edge connector. Spliced it into the Z slot ground and controls are working fine. Stupid rookie mistake. Thanks again for...

Thanks again for the reply. I see color changes when pressing player 1 and 2 start buttons...also I do hear tones when I press player 1 and 2 start buttons. Looks like I'm off to get an LS157. Anything else I should get "just in case?"

Test Mode shows no error codes, no beeps. No trackball or fire button inputs as well. I followed your advice and fiddled with the DIP switches..no change.

I've been playing with this thing for three days...still no trackball/fire button input. Voltages are good, harness is good. I think I've got to basically replace every RAM that has anything to do with the fire button and trackballs. Unfortunatley I don't have a logic probe to test every...

Thanks for the offer..where are you located ? :) I double checked all the wiring..no problems with the ground. I find it awfully odd that BOTH trackballs and BOTH fire buttons have no input.. Voltages check out okay. Would a bad E3 always show up during the self test? I feel like I'm...