Recent content by Robran68

I might have the whole board with two rivets, what's it worth??

Prayers to you buddy, hope all goes well for you. 🙏

Yes I know that, I'm basically trying replace some burnt to a crisp boots with trashed springs. I want to replace the whole boot assembly with a more robust diode and solder the anode wire to it, then wrap the ends with some 3M 103C. The VARO's are brittle as hell and difficult to solder to.

Huh....nobody??

Hello all, I know this has been discussed before but wanted to verify if anyone has successfully used a NTE527A or NTE505 diode in G05-802 and V2000 monitors? Also, can you post a pic of how you mounted them in the cage as they're a bit longer than the factory diodes.

I'd be hard pressed to pony up the original $29.87 for it! So someone actually has a bid on it, or it's a shill bid most likely.

Just my 2 cents, Johnathan if I was in your situation I'd just make peace with Harry and finish the deal with him. Reason being after all this drama it seems that Harry is a legit buyer and would probably still make a deal with you. Truthfully, I'd be hard pressed to pay $1000 for that rotted...

Sorry I would not.

Yes it is

$200 shipped to lower 48

Bump $225

Now $200

Now $250

Now $125

Bump