Need help, does anyone know where to find a d9400 service manual. If so please post or email me [email protected].
Working on one that blew the hot and the b+ starts out at zero and slowly rises to 180.
Does anyone have a schematic for this monitor? It is not 29ES1. I am trying to confirm the Part# for the mode Ic 801 think it is h06co1565rt??
Thanks Rick
Yes it is The 2SD1879. Definitely not the the same as an NT2515. Some similarities to a 2700 full family. It had a dead primary supply, then bad smps supply, then not oscillation so no high voltage. Had a to change a couple sweep caps and the Hot.
No I have one of each in front of me. There are a few differences. For example the 2525c had the signal input on the main board the 2500 has it on the neck board. Small differences in the power supply as well as others.
Every time I think I have seen them all, something else pops up.
Does any one have a Neotec NT2500 and confirm the correct HOT part #.
i believe the following is correct for others:
Nt2700 Full family- BU2532AL
NT2701 Lin Shi - 2sc4542
NT 2501 - 2SD187
NT 2502 -2sC4542
Nt 35C - 2sc4542
NT25C - 2SD1879
NT25E- 2SC1879 or 2SC2542
Not sure about the NT. 2500 I...
Neotec Hots:
Neotec 2701Family version uses Bu2532
Neotec 2701 Lin Shin, NT2501 NT 35C usues 2SC4542
NT2500 and 2515 usues 2SD1879
NT25E usues 2SD1879
The 2542 crosses with NTE 2354
All use 2SK1507 for the regulator except NT35 usues 2SK1358 this s based on what I have seen in the nauals, canno...