Recent content by RFWarrior

No, that's wild.

I had one that was glitching a bit, it would jump and glitch for a split second. Buffet fixed it.

I don't have a CRT to put back in *but* all original hardware is there I didn't remove or destroy anything at all.

when in doubt bump it out

Black Tiger in HS1 $1000 $900. Cab in good shape. Some scuff I've hidden with black tape but nothing too bad. Running 4:3 20" LCD Dell monitor w/ scan line generator. Looks and plays great. Original board not bootleg. Tri-fold HS-1 control panel. Located in Summerfield, NC 27358 Period perfect...

$40 each. Prefer local pickup 27358, but could ship with *actual* ship costs paid (don't want to estimate, they are a bit heavy). One Data East (SOLD) was pulled from Sly Spy. One Sega from Clutch Hitter. Not sure about the other black one. See images. The Data East panel only has the holes...

Rygar in Dynamo HS1, tri-fold CP. All NOS artwork not repro. Board has a sound issue on boot, but after reboot is fine. Probably a cap on the PCB. Again, plays/sounds fine once up and running. Proper matching build with correct button colors and correct period joystick. Cab is in good shape...

Bump...

HS1 with Tri-Fold control panel, Rastan theme. Running Game Elf 512, wired for Jamma. Monitor looks good, cab is solid. This HS1 has the board and power supply mounted on a slide out shelf. I also have a Rastan board, was having sound issues, it's not the board as I swapped the board and same...

Mat Mania in data east cab. Custom build. Cabinet is solid. Jamma adapter for other boards. 20” 4:3 LCD w/ scanlines. Two player setup for Mania challenge. Looks and plays good.

Street Fighter 2 - Anniversary in Z-back *Sale Pending* Street Fighter 2 in red Z-back. Running Anniversary Edition CPS2 (all speeds/modes) has had suicide fix. Monitor recently capped, looks excellent. Audio amp and better speakers, sounds amazing. Cab is solid. Little stickers are coming off...

Here is the test screen

I just acquired a Tempest. I’ve never owned one before so have really no background of known problems. Game boots fine and plays but screen is wonky with a convergence issue I think. Any tips on where to start / what to do? I wanted to reach out to the community before tons of internet searches...

Looking to get an afterburner PCB repaired. Board boots and plays fine for a few minutes then starts having odd problems. Upon failure shows IC30 fail. Don’t have time really to spend on it, looking for repair service. Thanks! James

I believe it's a Taito connector, I used a Jamma adapter on mine and wired it for jamma. It shouldn't be difficult to go with a jamma adapter and modify the Konami adapter. Someone may know it it could work as-is, but I doubt it.