1. Monitor Power Supply output high and not regulating. C112 and C114 (22uf 50V Electrolytic Caps) replaced. This can also cause the Monitor to trip.
2. East –West not adjusting. Check D134 and D135 for leakage. Also check the Horizontal size adj as this also effects the E/W
3. Tripping (Ticking Sound). Scoped output of Line Output Transistor. Very small Square wave low volts pulses. Flyback faulty. In this condition R227 was getting extremely hot
4. Shading on side of screen and streaking on picture. Check R36
5. Not starting up. Check C181 (4.7uf 250v Cap)
6. Picture Shimmering, Ripples and line pulling, Check Caps on secondary of Power Supply. C123/C129/C166
7. Lines on top of picture. Power supply set too low
8. Tripping, Check Line output transistor. Remove Transistor and connect globe to power supply. If output Ok. Transistor could be leaky or Flyback is faulty
9. Power Supply oscillates with no load but does not run with a load. Check R111,R112,R113 (1.5Ohm Resistors)