Recent content by ppaauull0

Ms pacman with 60 in 1 pcb, very nice original condition I have a very nice Ms pacman. Its running a Lizard Lick Pac to Jamma converter and a 60 in 1 board ( the good quality one) Every thing is original apart from the monitor which was replaced with a Wells Gardner. I am looking for sensible...

Right, iv'e found the wires but they don't match up colourwise with the ones from the coin door. What is the plug in connector fixed to the right side (looking from the back) of the cabinet near the bottom for as it doesn't appear to go anywhere?

The molex is intact on the coindoor side but there is nowhere to plug it into the harness. There is a molex from the controls into the harness but thats it.

The coin door wiring on my Ms pacman has been disconnected, I need to know how it connected to the main harness as all this has been removed.

If its only the pink thats faded try polishing it with a semi-abrasive car polish, it works a treat. be carefull not to take too much off but it will take it back to almost the original colour. I've scanned the internet and nobody mentions this trick, i can't be the first to do this can I ?????????

On the second photo you can clearly see the before and after on the pink strip using the car polish. I have looked on loads of sites and nobody has mentioned this, I can't be the first person to this can I??????

The pink was very faded so I tried using a car polish to remove the faded layer, it worked a treat. If you have a badly faded Ms pacman, and most are, try this, it really works. There is some damage on one of the sides, someone has scratched their name on it so this will have to repaired, apart...

This is my new project, a good condition Ms pacman. I paid $150 for it and its totally original.