Recent content by ph4ntomlord

PM incoming!

Fair enough. I appreciate any and all insight man. Thank you!

Do you think it's one of the millions of inductors and capacitors up by the edge connector?

If memory serves, I remember checking green from the edge connector to that chip, and it had continuity. I'll have to double check to verify though when I get the chance.

Everything is being tested on the LCD through the Supergun. All other PCB's display green just fine..only the Blitz PCB is missing green.

I haven't connected it to a CRT whatsoever. I tested the PCB on my test rig (supergun) that's connected to an LCD monitor. All my other PCB's work just fine on that setup...all colors, etc. So im assuming it's an issue on the PCB itself.

I do not have an oscilloscope...nor do I have an ly schematics at hand.

Yes, I have considered it. However, with the appropriate guidance...I would like to try and tackle it myself. Worst case scenario I would be more likely to contact the company you provided. We'll see what happens. 🤷🏻‍♂️

Still gotta bump this one!

Any help is appreciated!

Yes, I do have the tools

I appreciate the info @demogo, thank you. Of course I would still like to try and tackle this..if I'm able.

Care to weigh in on this discussion @WindDrake?

Any Seattle PCB experts out there?

Cleaning the edge connector was the first thing I did before I tested it...it's something I normally do with all boards before testing. Also, I haven't even hooked it up in a cabinet yet. Testing has been solely on my test rig setup (LCD montitor), and all other games work with no issues...so it...