Recent content by Nostrildomus

Bally Flash Gordon (are you getting sick of hearing that?) The top target keeps firing after it is up. There is no capacitor on the contacts and they are not too close. Any other suggestions ? Thanks for all of the help I have recieved... I am soooo close to being done !!!

Re: Pop Bumper won\'t fire ? That did it:) Thanks for getting me to re-check that little bugger.

Pop Bumper won\'t fire ? I have a Bally Flash Gordon that you folks have been helping me fix. I am down to a few minor issues. The right Pop Bumper won't fire. I can force it to fire when I ground the resistor to the side rail. It has the proper voltage. It doesn't fire when struck or when the...

I was having problems with the outkicker solenoid sticking on in my Bally Flash Gordon. I had no success in troubleshooting it so I bought a known (they said) working one (Solenoid Board). Now that outkicker solenoid fires appropriately, but others are sticking. What gives ? I am losing interest...

I have received great help (Thanks Ken L.) in getting my Flash Gordon up & running, but have one last request. I have the Outkicker Solenoid stuck on. I have disconnected the thing & replaced all of the bad Solenoid driver components that I can find. Any other potential trouble spots ? I am...

Bought a great pinled for $35.00 shipped & am now tracking down the transistor issue. Thanks everybody for all of the great advice

I recently bought this board (Ken's suggestion) for my Bally Flash Gordon & was very impressed:)

Got the board this evening & it powered right up:) No solenoids (except flippers) were working. Replaced 1 amp slo-blow & then Solenoids all fired, but the ball eject solenoid is stuck on. Looked for shorts etc... without success. I have a bad LED display - any clue where to buy a used...

I ordered an Alltek replacement board and will keep you posted. Thanks for the advice:) ...Kenny

I inherited a bally Flash Gordon - non working. It powers up, but the MPU led just stays lit. I have been to all of the usual web sites for troubleshooting advice without success. Should I just buck up and buy an Alltek MPU replacement ? Would this likely solve my problem ? Any advice would be...

I am looking to replace mine since it has many alterations. Not concerned with the overlay, just the style that fits my Data East cabinet. Thanks...Kenny

Bought a degaussing Coil and it came in the mail today. Within 30 seconds of it leaving the box my monitor looks flawless. Huge Thanks to KenLayon & DogP for the great advice:) ...Kenny

I got the monitor up & running. There is a patch of screen about 3" x 8" on the right side of the screen that the colors are not right. Any suggestions Ken Layton

I just bought a new Betson Imperial 19" monitor (44-4019-02); I haven't a clue as to how to wire in to my Commando Upright. Do I need an isolation transformer ? It shipped with an additional wire bundle that plugs in to the chassis that has R(red pinout from the PCB?);G(green pinout from the...