Recent content by mrsyfy

They are designed for 25" -29" monitors.

I would like to order one for an X-Men. Just give me a link.

I would like to order one for an X-Men

Not had any bad ones yet. Both use a lot of different suppliers, I do understand that. I have testes on hand to test with.

Are they still available?

Both Amazon and temu have them in stock.

How many do you have left?

I am looking for a monitor bezel and the bottom field plastics. The pacman and ms. Pacman plastics.

I am in need of a transformer for an eightball deluxe limited edition.

It's a simple trick, remove the connector cable from the board and the video card. Connect you vga input to the video card. Then on the dip switches up by the modem turn off dip switch #1. That puts the output of the board to low resolution. Then your veg monitors will display the video. I use...

If the rear gren light is ot flashing, that can be a issue with serveral different areas. The memory, u15 the BOOT ROM, U51 the SECURITY ROM, U26 SECURITY ROM or the video card.

for those still looking for photos. I could usea schematic of the neck board myself.

It's best to replace all the sockets. I did that to a couple of boards. Along with removing the video connector and soaking it in tarnex for a day or so to remove the corrosion from it. Also took brasso to all the surface mount it's and use a small steel brush to remove the corrosion off of...

I am looking for the u61 security chip. Does anyone have a sorce?

Best thing I have used on the edge connectors is silver polish and tarnex. Put a little tarnex in an ultra sonic cleaner lined with painters tape. Sit the ic chips in the solution with it on and you get nice and Shiney pins again. Clean the pins real good after that. Then retin them with a...