Recent content by masterfx

  1. masterfx

    Coin box for Dragons Lair wanted

    If anyone has a complete, with lid, message me, thanks!
  2. masterfx

    Cinematronics Dragons lair Coin door wanted

    Anyone has one to sell, PM me, thanks!
  3. masterfx

    Tempest restore running but with issues

    Hey, yea Jason, all voltages are correct now. I posted this before speaking to you on FB. I appreciate everyone's input!
  4. masterfx

    Space Invaders went blank and repeats sound fx

    Anyone know where to start on this? Worked yesterday, turned on and its repeating sound effect and screen went blank. see here: Problems
  5. masterfx

    I saw in a post you had and extra x/y board by Barry. Do you still have and will you sell?

    I saw in a post you had and extra x/y board by Barry. Do you still have and will you sell?
  6. masterfx

    Tempest restore running but with issues

    Finally got my Tempest restore working but some issues. I have Jason Kopp tempest board and IM wondering what that runs under load? I tested the 5vdc on the power board disconnected and was getting 5.3v. When I connect the board Im getting 3.8v. Reason I even checked is because Im getting some...
  7. masterfx

    Tempest (where do these wires connect?)

    I bought a new harness for my Tempest restore. There are 4 wires zipped along with the two that connect to the volume pot. What are these and where do they connect?
  8. masterfx

    Tempest Molex ID?

    Can anyone tell me the part numbers to these two connectors and where I can order them? I ordered the 15 pin Molex but it is not keyed like the Atari one so it doesn't connect. The other runs into the coin door. Thanks!
  9. masterfx

    Tempest monitor Bracket 037750-01 wanted

    Trying to finish my restoration and need this monitor bracket. Let me know if anyone has one to sell.
  10. masterfx

    Atari AR -II test point lugs never installed

    My AR II Tempest board doesnt have any of the test point "Lugs?" installed. I would like to run a 12v fan off this board as well as for testing voltages. Does anyone sell these that I can add to my board or have a solution? Im a newbie and every video I see testing voltages are hooking up to...
  11. masterfx

    Installing outlet in Tempest cab

    Alright running new outlet plug makes sense. That being said, couldnt I just buy a cheap 120v to 12vdc transformer to plug into the outlet and run my fans and LED marquee? That would seem to streamline this whole thing?
  12. masterfx

    Installing outlet in Tempest cab

    So your saying if I add an additional Molex to the empty spot on the block, and bridge the wires from the 120v Molex to the additional Molex I should be good to go or is that a bad idea? drew some lines on my pics
Back
Top Bottom