Recent content by ManCaveArcade

Does anyone know what coil will work in a zombie raid gun? Mine shorted out and there is no numbers on the coils. The manual does not list it either.

I posted a picture, it is the second photo from the left. Sorry it is not a very good photo, lighting sucks in that area. They are a sit down game with pictures of old famous wrestlers around the bezel (hulk hogan, etc.) the farther you pull his arm down the light light up to "beat" the...

More pictures Games are located in Erie, PA

pictures Here is some pictures.

Here is a list of games for sale. I will include some pics but there is too many to post so if you are interested, let me know and I can post more. UPDATED SOLD GAMES 2-3-17 GAMES FOR SALE 1. Cabal: Plays blind. Cleaned it up and put on a new control panel plexi. $300 2. *** SOLD*** Quick &...

buttons It is for an aftermarket PS3 Guitar, using a PS3 in my game. It's not the contact itself going bad, the rubber basically breaks and falls apart after weeks of constant abuse. I will try ordering the controller ones and maybe I can cut them and make them fit. I'm thinking there has to be...

I bought these nice guitars for my Guitar Hero game but the buttons don't last very long. They are really small rubber like buttons with a contact on the bottom. They spring back up when pushed on. I have looked all over the net but I'm not sure what they are called so it made it hard to...

I have a fully working Pole Position 1 PCB set (2 board stack + interconnect) This board was just serviced by KLOV member MIKERK and will be drop shipped from his shop. Asking $225 + shipping. NOTE: This game is known for bad edge connectors. It is recommended that you re-pin the female edge...

Thanks for the replies, I will look into the alternate video cards.

I have been working on a set of 4 Road Burners but I have 2 that have issues with the graphics card. It is a strange hybrid of a board set and computer. I have swapped graphics cards from the working ones so I know the issue is there. Is there a new replacement graphics card for this game or...

I am so close to a complete restoration of this 6 player XMEN that I found. I have a PCB but it has serious corrosion and has developed issues so I am looking for another PCB. I prefer a working PCB, but I will take a non-working board also as long as it doesn't have serious corrosion and is...

The sooner, the better. I have about 4 games that take this chassis out of order and 2 of them are not repairable. Just let me know when you finish it up, I'm sure I'll still need it. Thanks.

I really need some U5000 chassis' in full working order (preferably re-capped with new fly). I could use 2 or more if you have any, please let me know. Thanks.

Thanks PCJOHN, I will try to install a cap kit and reflow the solder and see what happens. I hate those monitors, there is like 20 security screws holding on the metal box just to get to it and it's so heavy that 2 people have to take off the box. Then finding parts or anyone to work on them is...

Have you tried the local hardware store? I run into spring problems all the time and I take the old one to my local "True Value Hardware" store and they have a large variety of stock springs. Although it may be tough to find an exact match, I am often able to get one close enough to work for the...