Recent content by M_May41

I have three audio boards for SC I'm beginning to troubleshoot. One Is a Rev C. and It appears to have a couple of ceramic resistors and also a couple of diodes added close to the corner by one of the heat sinks. All mounted vertically for lack of space. One of these diodes Is fried and I cannot...

I have one for an upright but the art Is different. I haven't checked to see If the button layout Is the same or not. If It Is I could trim It to fit, but I'd really like to find a match to the original If possible. Thanks for the Input

Anyone have or know where a guy might find an Asteroids Deluxe Cabaret Control Panel Overlay. Any help appreciated. Have lots of stuff to possibly trade or cash Is fine as well.

I'm working on this K7000 and VR8 checks open so I assume It needs replaced. What I need to know Is how do you adjust the new one as the original Is factory set and they glue the thing In place. I've gone through the manual and see no reference as to how to set a new one. Can someone help me...

Thanks for the help guys.

Can someone tell me If there Is suposed to be a mica Insulator between the heat sink and the collector on the K7000 HOT. Thanks In advance for your help

I'm working on a K6100 with a P314 with the IPC upgrade. and I'm looking for a .001uF +/-20%, TypZ5F capacitor. I'm reading about this upgrade here http://westnet.com/~chris/arcade/F_Greg_Woodcock5.html. It doesn't say but I'm assuming this to be a 500v cap. Not sure what the Z5F means but I...

Does anyone have or know where a guy might find a Gottlieb Reactor for sale. I've looked on e-bay with no luck thus far. Any help would be appreciated. Thanks

Idaho. In the Boise Area

I have a 100% working Stargate (I have a new cpo and buttons for It but not Installed yet) I would like to trade for a Tempest Or possibly something else. If anyone's Interested you can e-mail me at [email protected] for details.

A Defender board will run fine without even plugging the memory protect Interlock In. There will be no wire where It says Key. Some plugs are even closed there so they cannot be plugged In Incorrectly. Are you changing out the ROM board or the CPU board or both. You have to have the right ROM...

OK I replaced IC501. Same problem. Also have replaced x301 through x306 and tested all 400 resistors. All looked good except possibly r419 and r420 If I'm correct r419 should be 2200ohms and measures 2615ohms. r420 should be 5.6ohms and measures 6.16ohms. Both are over the 10% tolerance but not...

Thanks Ken Just wanted to be sure. The one that came out Is marked A1015 GR 2c.

Is x303 on the G07 the same as x301,x302,x304,x305,x306? They all crossed to NTE85 except for x303 and I want to make sure It's suposed to be different than the others before replacing It

I don't really know what It's worth $25.00 + shipping?? I'll even take It back and refund your money If your not happy. But you'd have to pay for the shipping back to me. Let me know what you think.