I don't mean to jump in, but it seems you guys know a little about the taito cabs.
Can anyone shed some light on this one?
I've partially tried to restore it, unfortunately the paint was hard to remove even with stripper, so I ended up being a little too rough with the scraper.
It has a Jungle...
Haha, oh dear.
I change ROMs wearing static inducing clothing, all the time. Never had problems so far.
But then again, if I'm dealing with something worth more than a few hundred, I'll use a band.
Might source the pic chip and have a go at it some time. MK3 is damn hard to find here
Hey there guys.
I have a bit of a request.. I recently burnt some roms for my MK2 board set to use the excellent balance hack (UMK2:TE). And this has got me wondering.
Is it possible to downgrade UMK3 to plain MK3?
I'm not entirely sure when it comes to the UMK3 board. Some chips are...
G'day guys.
I finally got round to wiring up my dkjr board and testing it. Seems fine except for a sync issue. Best described with a pic;
This pic is taken after I figured out I had left the monitor ground off (part of the rgb loom).
I connected the ground on dkjr, which is right next to the...
And that is the state of the boards.
Whole cabinet had a thick layer of dust in and on it. Unused for years I guess, the fan needed to be oiled.
You'll notice that there are no plugs on any of the wires. All are soldered on :(
Will get some better pics tomorrow
G'day. I'm quite new to authentic machines. No stranger to building tho.
Right off the bat, i scored a cheap Paperboy cab. Not the original cab either, it's a tempest cab with wood grain pattern.
It boots, it plays.
Except where letterbox and obstacles should be, is a line of blocks of...