Recent content by LeDavester

Well , first of all , you should check voltages on both cabinets without a board in them, obvious shorts on the connector or in the wiring of the cabinet. Maybe it's something simple , that happened during transport. Mesure that 5v with the board plugged in (dangerous if the board smokes of...

I need the following chips for my T2 arcade board : A-5346-40009-1 -> U8 IC, PLD Color Ram Ctrl A-5346-40009-2 -> U40 IC, PLD Address Decode A-5346-40009-3 -> U53 IC, Video RAM Control A-5346-40009-10 -> U42 IC, PLD Local Control...

Here are a few suggestions : Does the board have any self-test you could do ? I mainly have midway boards , and they all do have rom tests , either at boot up , or in the service switch menu. Do all tests , and see if any errors come up , if so , post them here. Is the cabinet an original...

Hehe , i have put coins in the following way : service coins / coin slot(s) / and free play. If no coins are inserted , it doesn't reset it prompts me to pay. I have also made sure the 5v is steady (4.87) and that is enough for my other "y-unit" board , which is an original mk1 cabinet. It is...

Hi , i have posted this about a year ago , so i am asking again. I bought a Terminator 2 board from ebay , which came without the board for the guns. After closer examination , i noticed it didn't have the needed connectors to plug that board in. So my guess was that chips from an original T2...

Hi, i have the manual for T2 , here are the dipswitches : DIP1 1:mirror display 2:Coinage (DIP SWITH or CMOS) 3/4/5:coin settings (ALL ON = FREEPLAY) 6/7/8:Not used Dip2: sw1 sw2 USA off off German on off French off on not used on on 3:Not used 4:One...

My killer instinct board , which was stored in an anti-static bag for months , now shows a blue flickering screen on startup, and won't start at all with the HD connected. I decided to mesure voltages of my jamma connector, and i am getting -4.1 volts for the -5 now , that is too low right...

Too much

Revision LA1 dumped... I took the time to dump it before i go to bed, here it is : T2LA1 It boots with mame , but crashes just before gun calibration .. Cheers

I think i might of figured out the problem of my T2 arcade board which is missing the connectors for the guns. I have a revision LA1 , and the only 2 dumped on mame.dk are LA2 and LA3. I have wired psx analog controllers to an ADC and wired it to the missing connectors on my T2 and it works...

Where are the pinouts for the following signals : d0-d7 ADA0/ADA1/ADWR/ADRD I'm guessing they are on the jamma connector.. HELP!!! thnx

According to the wiring manual of my terminator 2 jamma pcb, The guns are plugged on a coil lamp driver board, which is an analog to digital converter, It then sends the 8bit data to a connector (j12) which is inputs 32 - 39. That connector is non-existing on my cpu board. The pins were it...

Hi, i am new on the forum , but an avid follower of klov for a long time now.. I have recently bought terminator 2 judgement day on ebay. Game came with the Cpu board and sound board only. I also received the original manual (which i am in the process of scanning , and making a pdf for you...