Recent content by kmeyer37

Background on what i've done//problem(s) - Original issue, High voltage fires when plugged in but shuts down within a second of being plugged in. No heater glow. Monitor still sounds as though it's on but no raster at all (No HV) - Recapped the following...

does not work in either direction

I have a wg k7500 on the original 27" wells tube with a 9A3012-001 Yoke. The k7500 is set up for 27" use and has pincushion board installed First question I have is, is this the correct yoke for this chassis? 2nd question I have is, why I cannot adjust the width? I entire deflection board...

Attempting to resurrect a once working K7300 19" Chassis. Plugged it in, fired right up, but after sitting on for an hour or so a ripple appeared to wriggle through the entire picture. There was also a small amount odd horizontal lines at the top of the picture similar to vertical foldover but...

well there was actually several problems, lol. 1st was the fact that my meter was not working correctly, I did in fact have B+ but my meter wasn't reading anything even though it was turning on fine... 2nd problem was the tube i was testing the U5000 in was pretty washed out, and I could only...

Went through all the resistors in the general vicinity of the flyback but found nothing open, including the 2 thermistors. C107/305/725 also test good. Edit: I found the problem :) Thanks for you help buffett. Now to just find a decent looking 25" tube...

So I have several U5000 Chassis laying around the shop here that were sitting here non-functional prior to my arrival. I need to to get one going for a Cruisin' USA that is being sold to a customer, so I grabbed the only that actually looked complete and fired it up. Was clicking, so I...

Thanks for the responses from everyone. This got back-shelfed for some time but ended up being a combination of both the flyback and the improper tube... Sorry I did not message back sooner

Hello everyone, I am somewhat new to the forums here. I have followed several threads in the past including repair log threads by Modessitt, nice work there by the way :), but decided it was time to donate to become a full member of the forums. I work at an amusement company in Southeast...