Recent content by justifier112

Thanks!! much appreciated!

i just sold a pac- land pcb with marquee and manual last week,150 total for all on craigslist,,,, it was on ebay for a month only one for sale in the USA,

looking for a number 4,, used on defender and stargate and maybe other williams cabinets.. thank you

mine just has the spring, then washer then a snap ring

i will check

hope this helps a little,,

steve pushed that monitor off the racking

i have a williams sound board in mine and apparently it suppose to make bull sounds,, i seen one making sounds on youtube, so spend some time searching tube and you will find it

need help, i got power going into, but not out of transformer, hard for me to find a proper replacement,, green wire on the O goes up to the lights, the white wires on the 12 and 24 go to the williams sound board,,,, can you point me in the right direction? what lights and fixtures do you use...

yes, all fixed and works like a champ, the tabs that have the hole for a pin to attach the vend arm were bent out slightly, so when the solenoid would pull in, it would get stuck and not drop freely down, I realized I may have bent those tabs a bit on disassembly, I took it back apart and used...

on my vendo 63, I put coins in, the solenoid pulls up inside itself then I try to pull out a can of pop and I can not, then I use my finger, push down on the arm that attaches to the solenoid all the way, I can then open the gate and remove a can and when I let go of the gate it all resets as...

I think thee leds hold up better than the incandescents do

on my flying saucer em ( I know its a different game) I had 2 bulbs that would always burn out within the weekend, so I replaced them with leds, have not burned out yet

yea, and they didn't even have to put their own quarters into the games and they complain

then super lube it is,, thanks!!!