Recent content by jp.jones

@dickmillikan Thanks for offering - I sent you a PM

No need to be sorry! I did check around and while ebay was pricey I did find a site that had them for less than $5 a piece (I need 10+). I reached out to them and haven't heard back, rather than try to deal with someone who could be potentially shady, I figured I'd ask here in case someone...

Thanks for responding, I saw those, but I need the 32 pin dip version. Updated title

Hi Team, I'm looking to buy 27C080 eproms 32dip version - anyone have any from your now defunct junk boards? Thanks - john

I emailed the guy with the clone,, wanting to get one but have no answer to date. All sucks in the wait for a replacement board.

Hello, thanks for the reply, I suppose that I can just solder the pads that are there on the video section. However, on the volume, the pad circled doesn't have a trace on the top or bottom, but when held up to the light it appears that there might be something in the middle. (compare my...

Hi Andy - I'm attempting to troubleshoot the board in the only way I know how, and that is by process of elimination. But, that's beside the point, as I was hoping that someone here might show some kindness and point me in the right direction on where to solder the legs.

Hi Team, I was having issues with green being too prominent and the volume would cut out/get real loud, so I thought I'd start with replacing all the pots on the vidiot. I ordered pots with the correct values and went to task de-soldering the ones on the pcb. The green pot legs were rusted...

I made a custom underlay and CPO design in adobe illustrator and would like to have them printed (they will be going on a Pac-Man cocktail). About 6 months ago, I sent messages to the 'usual' places but either received no response or was not followed back up with when I responded to their...

The 'hotkey' is configured along with your controller setup. I don't know if you can map a hotkey (to say... like P2 start) and then use it to actually register a button press in-game to start a 2 player game... I guess only one way to find out....

Thank you for the info and response. Here is what I've learned about using a Jamma4pi. After you burn an image to a sd card, add the configuration lines into the config.txt file. The Jamma4Pi treats your cabinet controls as a gamepad so you'll want to have everything in place and connected...

Hello, You can use any image that you want, just keep in mind that after flashing the image, add the special config lines into the config.txt file. It will boot up in 15khz mode and display the screen. It's a little bit easier than that, and I would recommend a pre built image because...

Hi Gang, So here's the situation... I recently purchased a Jamma4Pi and a raspberry pi 3 b+ and was hoping to put it into a jamma cabinet where the motherboard failed (this was Jpac, computer, hdd etc setup). I used an image from the 'punks site (800-1 vertical), put it on an SD and fired up...

Just received mine in the mail today. I have to say that the panel exceeded my expectations and is worth every penny. Thanks!

No problem, thanks for looking. Lost World was from '78, I thought it might be easier to say '79 because it appears in that catalog. http://www.planetarypinball.com/reference/partsmanuals/BLY_Parts_1979/files/mobile/index.html#1 Thanks!