Recent content by jibmums

Since this is essentially Sega/Gremlin-based thread, I have a question - I'm looking for some good high-res photos of the "side wings" of the Gremlin Moon Cresta bezel, the parts that attach on either side of the main bezel. Anyone got or can take some?

Deep Scan Dual Invinco N-Sub So rare, the unicorns of the Sega/Gremlin games.

Tell me about it. I have two Black Knight (1980) pinballs that couldn't be more different, both cabinets and innards.

Interesting, I haven't seen a Pit before with that "close together" carriage bolt pattern. They've all either had them lined up on the upper corners of the white/orange/red stripes, or moved inward about 1/2" or so. I thought I had seen one or two with a four bolt pattern also but I can't find...

All of them? I have a Monroe stick modeled for my Time Pilot, but I've seen pretty much a 50/50 split in all the photos I've collected between Monroe and Wico, so I went by the flyer photo which is a red-top Wico. Interestingly, I've also seen three different arrays of carriage bolts at the...

Not sure what you mean, I don't see any areas of solid blue missing. There was a little clipped from the sides but it was negligible. The only thing I would have incorporated but it would have been a pain to do is where the red stripe overprints the blues, it's not completely opaque on the...

Here's what I'm using it for, a 3d model I'm working on for 3dArcade. I'd love to do the whole range of the woodgrain Centuri games, but artwork, or even decent photos, of the rarer games - Roundup, Challenger, D-Day, Locomotion, Route 66 - is just impossible to find.

It doesn't look like too much is cropped off, I should be able to recreate the little bit that's missing. Thanks guys!

I need to recreate the front of The Pit's control panel, part circled in yellow in the pic attached. Wondering if anyone happens to have access to this game could snap a couple of good photos and post them here, and also indicate the height and width of this part of the artwork. Thanks!

Thought you guys might find this interesting, part of the the Showcase Showdown was a rare Centuri "Round-Up" on this episode on Youtube. I wonder if the cab still exists or is long gone.

It had rev 2 until last week. I have a spare BK MPU that had rev 4 roms, so I swapped them over. Not really noticing any differences though. I have a second much later build BK with the system 7 power supply, and I've been noticing some interesting differences with this early build one. Like...

Hey Charles, my BK that I'm putting the finishing touches on right now is yours's slightly older brother. They were likely manufactured the same day!

Put game into switch test and test the three trough switches 10, 11, and 12. Game won't start unless it recognizes three balls in the trough.

You should slap some removable mylar to that spinner, otherwise in six months it's going to look like every other used, worn spinner.

When I was fixing up my Xenon last year, I too was getting a ton of "static" (for lack of a better description) in the sound. I pulled the sound board, check all the 0.156 pins and reflowed one cold solder joint, and replaced the little red test button fixture (the front and button of which...