Recent content by JeremiahJaxxon

  1. JeremiahJaxxon

    How to Add Custom Sounds to Any Claw Machine

    New episode! Hope you guys enjoy: Special thanks to @testfly !
  2. JeremiahJaxxon

    Marquee Collection

    You two are still the only two. It’s a hard list to get on.
  3. JeremiahJaxxon

    Marketplace find..how high is the seller?

    I don't know about that, but I can definitely advise you to drink spirits.
  4. JeremiahJaxxon

    Looking for a good reproduction underlay for my Pacman cocktail

    ArcadeShop used to have a pretty good, cheap paper underlay for Pac-Man. I think they were out of stock when I got mine, but when I emailed them directly about it, it turned out they had just a few left over. Might be worth a shot...
  5. JeremiahJaxxon

    What are my choices for a claw machine that fits my needs?

    Oops. I woulda bought em. Sounds like something shorted near the bridge.
  6. JeremiahJaxxon

    Hello all!

    Considering how easy they are to break into, I think it's the latter.
  7. JeremiahJaxxon

    Hello all!

    Haha, I remember trying to bring one home when I was 22, ended up dragging the thing inside on its back. Swapped the casters for floor sliders so it'd fit under a door. You'd think these manufacturers would design the things to be 100 lbs lighter and to fit through a standard door, that way one...
  8. JeremiahJaxxon

    Hello all!

    I don't still have my machine, but I do recall that there was not a separate light behind the CS marquee, it was lit by the overhead lights for the cabinet. That power switch should be there, in between the incoming power line and the transformer, unless someone bypassed it.
  9. JeremiahJaxxon

    SOLD - PARTS ($200, London KY) Galaga PCB, Control Panel, Joystick, Low Voltage Transformer, and Wiring Harness

    Up for sale is the PCB, Control Panel, low voltage wiring harness, and low voltage transformer from my original Galaga machine. I did not hack up the harness, I simply desoldered the connections that were directly on buttons / lights. This would be almost everything you need to turn a converted...
  10. JeremiahJaxxon

    SOLD - GAME House of the Dead PROJECT- Corbin, KY

    FINAL WARNING- Disassembling soon.
  11. JeremiahJaxxon

    What are my choices for a claw machine that fits my needs?

    With the machine I had pictured, it either used a potentiometer or rheostat for controlling the strength (depending on the PCB revision, I owned a few of them), which could be adjusted to anywhere between "decapitation hazard" and "impossible to win". I also had to remove a small ramp from the...
Back
Top Bottom