Recent content by jbraun

Hello, I'm looking to buy a Tron Translite. Thanks

So, while I had my joust cabinet opened I noticed there's quite a bit of dust inside on the cables and pcb's. Do you guys recommend just leaving it or getting compressed air to spray it all out? Are there other cleaners? Thanks! Jason

Hey Guys, I finally figured out what the problem was... The player 2 switch was stuck on the inside somehow, because when I gave it a tap and then turned the machine back on, everything worked fine again. Thanks so very much for helping me out today. I really appreciate your kindness. Jason

I think I was disconnecting from the wrong board, so I opened up the back of the machine and found a really small board with two sets of cables plugged into it and then a ribbon cable out the other end. When I disconnected the cables from the joysticks, plugged it in and then went back to the...

with all the cables connected to the widget it reads: Move Left 1 Move right 1 flap 1 one player start move left 2 move right 2 flap 2 with all the cables disconnected it reads the same.

I disconnected all cables from the widget board and it still does it. What can I try next?

Me either. I'm not even sure if that's the problem or if they're easy to swap?? Is there an easy way to figure out if its the controller contacts or the board?

hehe sounds fishy. Thanks, I guess I'll just start at the joystick contacts and work my way towards the boards. Jason

Hello Everyone, I just purchased my first arcade game, a Joust cocktail table, in really good condition. Everything seemed to work great, it booted up fine, diagnostics said everything was good. Then today when I plugged it in and hit the 1 or 2 player buttons (its setup for free play)...