Recent content by J69

Really? Loads of UK machines had them too and we don't have D&B over here

Bump!

That’s a shame, I’ve just found one of these remotes for my Daytona special. I’ve seen lots of threads asking for these remotes over the years. My Daytona has a pcb inside the cab with about 20 pots on to fine tune the convergence of you don’t have a remote. It’s playing with fire though as you...

Still looking thanks

That would be amazing if you did. The part number isn’t listed in the manual unfortunately. Long shot, but I’m also looking for the Hitachi remote for the same machine. Part number 200-5297

Anyone got one of these lying about please?

Thanks, I'll get some pictures of the board over the weekend when I get a chance to pull the cab back out. At the minute, adjusting the voltage pot on the chassis makes very little difference, so either the pot is broken or the chassis is losing power between the pot and SP15

It's European Chassis. I checked the manual for MTC900E and it definitely says to check the B+ at SP20 https://www.arcade-museum.com/manuals-monitors/Hantarex_MTC900-E_Europe.pdf Page 9, point 1

I've tested voltage at SP20 and I'm getting 81v. The B+ pot at max and min only produces between 79v and 84v

So the monitor is a Hantarex MTC900e I've found the B+ adjust pot but where do I take the voltage measurement from on the chassis? I've had a tweak with the pot both directions and it hasn't made any difference but it would be good to know what voltage I'm meant to be getting? Thanks

Thanks, I'll take a look this week. The cab has just been transported so something could have been knocked

I haven't had time to pull the cab out to check which monitor/chassis is in this but.... I turned my afterburner on yesterday and there were a number of issues -It took a good 60 seconds to show a picture -The image has shrunk on the screen. It's got a 2 inch black border around each side now...

Dupe post sorry

Haha, I lived in CT briefly when I joined this forum The issue I was having is that every time the QBs (I think) were clicking, the top left cylinder would jump. You can see it in the video below. I've adjusted the valves on the cylinder and the QB still clicks loudly but the cylinder no...

Can you tell me more about this? My quick breathe valves always click loudly at the same points in each race. The seat jumps slightly everyone they click. I've reduced this by adjusting the valves in the seat cylinders but the clicking noise is annoying! What's the issue with them? Can you...