Recent content by Homey244

Doesn't do anything to help. Pot appears good because it does change the screen some. After a little more research I think it may be a video board issue on the PCB. It appears as if many outruns have suffered from bad chips on the video board. I think my monitor may be ok.

Still available?

I am amazed that this chassis works just fine on burger time but won't work on the outrun right beside it. I hope it is a simple fix, I can't figure it out. Looks like this. Looks blue in the picture but it is actually grey. Game sounds fine playing through the attract mode but can't see...

One for me too

I will try to get a pic of what it is doing. thank you. What is your youtube channel?

i followed along with mikes amateur arcade repair on youtube as he was troubleshooting one, and found that the IC3 is grounded so leads me to believe that it is bad. also, shows several bad diodes, all of which happened after i capped it. just figured by the time i run down several parts from...

I have a vertical deflection problem on my P447 K7000. Looking for suggestions on guys who are fixing them. Thanks.

Polarity is correct

Bought a non working AD. one of the big 6800 uf 50 volt capacitors was dried out and missing its cover. Did a cap kit. Fired back up and had deflection board chatter but nothing on screen. While fiddling with brightness adjustments etc., had been powered up for about a minute, heard a hiss and...

I know this power supply was used for Popeye. What others did it work for?

I'll check into this.... Thanks

How can Rock Auto send 40 pounds of truck parts to my door from 500 miles away in a 24"x24" box for $14 shipping and it cost me near $20 to send a 10 oz arcade part the same distance in a smaller box? Just pondering this on a slow afternoon.

It isn't jamma. Are you saying mcr uses both horizontal and vertical sync?

Thank you. It is a place to start.