Recent content by Hawk777th

Think I got it handled my yoke is really low OHM and that seems to be causing issues.

New Caps Fly Back Hcoil. The line is 120-122V inside the cab. I got it from a member here. I dont want to fool with it and wreck it I guess I will send it back. The B voltage jumps when it goes off. The blue wire goes from 131V on to 145V when it shuts down. The red wire is 145 when on and...

Hi I just got a replacement board for my K7000 that was refurbed. My prior board had a strange rollover problem that couldnt be fixed it seemed. Also the Hcoil was non responsive to adjustment. So basically the screen was cut off about 1/4 on the right side and it rolled over backwards. I...

I did order a C38 that was factory specs just to throw in and see if it makes any difference. The thing is I dont know if its even the width its like the whole picture is shooting to the left to far.

Sounds good Ill be waiting! :)

Does this look correct for the vertical yoke? Showing 1.5 on the Horizontal? This is on my K7000.

Is that dark red one by the Hcoil C36? I cant see any markings on it if thats the one.

Thanks Mit! I trust you just wanted to get some more opinions before I decide what to do.

Here are a few pictures of the board. Not sure if any of them help. I have a local guy that could recap it but I am not above just getting one of your refurbed boards to throw in there so I dont have to go through the brain damage of chasing issues. I only have a multi meter so i guess I...

Can you tell me how to check that. I am a total noob. Do I need to pull the board out? This is my first arcade cab and I am trying to figure it all out still haha! :)

I am not aware of that function on the K7000? I have tried the width coil to no avail.

Hey guys first post! Anyways I recently got a Neo MVS 4 slot cab and it has been great. The only flaw with it has been an issue with the monitor. The monitor is crisp and bright with great color. That being said there is something causing roll on the side. I have a remote board and if I turn...