Recent content by hambuntu

Ken I have and they told me its blown. They want 275.00 to repair it. Anyone know a cheaper repair outfit? You are still my personal JC. Thanks Ken

i'm not crazy This box carries AMI, Ecast and Rock-Ola badges. If anyone has an explanation for this please tell me. My assumption is that this was an AMI box, later converted to Ecast and branded with the Rock-Ola name. It is my understanding that Rock-Ola's name has been sold around the...

Overload Light photos The second to last photo is the "error" in question. The last photo is the good side referred to in the first post

picks these are picks of the case and the top of the amp i will post picks of the lights as well. i will do the same on the other forum ASAP.

amp Closer inspection the amp carries the Rock-Ola name badge on it. I don't know why i did not see this before.

amp The cab i believe was once an E-Rock and the best i can tell was later converted to a eCast box. The number on the amp i gave you was printed on the bottom left hand corner of the amp, if that helps.

I am looking for someone with Rowe experience. I barely get any volume form my Rowe amp. A clock radio pushes harder. The amp in question is a 70135-a yellow in color. The overload light is on on the right hand side witch is labeled “internal amp”. However the other side labeled “external...

.pdf sorry thair were 4 switches per bank not 5, and it turned out to be the number two switch, a soon as i changed it i had video. thanks for all your help. why dont we have a place to post board manuals in .pdf format you know how handy that would be. i would scan and post what i have...

re i see 2 5 switch banks on this board i have changed the num 1 on both sepratly and it has not changed my situation. one bank is at the front of the board the other is near the video card is thair another bank i am missing, maby under the card?

standard res standard res. How can i check that, i have no book for this board and that is causing most of the issues. Or is it controlled on the mon. Thanks for the help i haven't messed with a arcade cab in a few years and i tend to forget more than i retain. thanks in advance for all the...

re golden tee 2004

i am running a w.g. k7401 and installing in a new cab. i tried my sinc on both vert and horz. not much luck. then i tied them both together, jumped from vert to horz. got some immage with a lot of trash. i am lookin at the schematick and i see grnd vert and horz on the three pin below the...

when we hooked up this "rebulit" mon. all the video we get is a white line center screen, Is this a cap or do i have it hooked up wrong?

thanks ken yet again you save my a**

re yes i found him, but my troubles have grown deeper since i played with this project the box wont attempt to track now when a selection is made IDN?