Recent content by gregr

The mother board and I/O are brand new never used from Namco, will the sync with each other upon start-up or does something need to be done to pair them Thanks Greg

I'm in a similar situation with my Rockin Bowl, had the game for about 11years, no problems and then stopped working. I was wondering if you replace the motherboard and I/O, will they pair with one another automatically upon start-up or is there anything else that needs to be done.

I would be in for board if it happens

Looking for a Centipede project, non-working, needs refurbishment. Looking for a cabinet with at least wiring harness and control panel, everything else would be a plus. Thanks Greg

Asteroids Extremely interested - I'm an accountant, so it's my busiest time of the year and tough to find time to make the 6hr round trip pick-up. I maybe able to have my dad and uncle pick it up, they love road trips, however, they would not have the ability to do anything other than put it...

You can add my name to the list - I'd take 2

Speaker Grill I'd be in for one

crystal castles is it still available thanks Greg

Looking for a working board set for a new project. Thanks Greg

Pole Position 2 Working one right now also, there is not a seperate set of schematics for PP2 that I am aware of, just an enhancement document that was for the conversion from PP1 to PP2 - there is no difference in the hardware based on the other posts I have read, I believe you are correct...

Picked up a PP II board untested, board boots up and begins to run the 3 or 4 screens before the title screen and it gets hung-up (stuck on screen with little man), it will sit there for 2 minutes and then reboot again and continues it over and over. I have not done the 5v mod yet but the board...

Spray gun I have tried a wide range of compressors sizes over the last 5 years and it really depends on what you are spraying. For example if you were spraying a bicycle frame the 5 gallon compressor would be, you are not making long strokes and proper overlap. I have tried spraying a cabinet...

Buttons Very exciting - glad they finally got done

The power supply in my DK is running low for 5v, read 4.8v and is causing some graphics issues. Positive that it is the power supply - tested the board in my DKjr cab. I tried to adjust the +5v with the variable resistor but neither of the +5v pots will budge, so much so that the plastic...

Update Replaced all 10 caps and we now have a working zoo keeper. Thanks Greg