Recent content by friedfish

It is a monitor I picked up for $40 that isn't working. Also goes by the manufacturer name of Eastern Micro Electronics.

Does anyone have a parts list for the Shinlee EM201? Have found manuals, but nothing with a parts list. I am trying to identify C-423, R353, and a transistor on the chassis.

I recently purchased a D9400 with a power input connector for which I can't find a connector that is the correct size. It seems to be double the spacing size of a 0.156" connector as a 5 connector fits (with the 2 and 4 pin locations empty) but I am concerned about the power draw if I use this...

Thanks for the recommendations. I swapped the yoke wires and the black area swapped to other side of the screen, so I was happy to see it was not a tube issue.

Hello. I have a K4900 monitor with a portion of the right side of the screen not showing a picture. This missing portion is still there when the picture rolls. Is this issue that can be resolved with a cap kit or is there an issue with the tube or the yoke?

I have the same board and mine stopped working. If I remember correctly, the selection menu comes up, but nothing else. I posted on the arcade project forums asking for advice, but no one responded with any ideas. I will have to try the link above. It was a great board when it was working.

Mrbill08 fixed a couple in the past for me, but I don't know if he still offers the service.

This a picture of the brackets that broke off. The strap that holds the brackets is still in place.

Are there any suggestions for the best way to reattach the metal brackets that hold the glass picture tube to the monitor/chassis frame. Two of the mounts are broken off where they attach at the rounded corners of the picture tube, and I was thinking of trying JB Weld as a repair but wondered...

I recently purchased an Arachnid English Mark Darts 4500, but some of the bulbs may be burnt out. Does anyone know of someone who sells replacement bulbs? It is Part No 11-0013 Lamp with Socket in the manual, but I have not found anyone selling replacement bulbs. Pictures below show the...

I bought a K4900 chassis and yoke from ebay, and the yoke arrived as shown in the picture with a portion of the red board broken off. Is this something that i can just hot glue back in place?

Tied to this coversation, I am attempting to reuse this same isolation transformer in a cabinet and have it wired up just as Mattosborn indicated above with the 110V jumper connected and the blue and brown (actually its purple) providing the output from the isolation transformer...

I have built quite a few PCB holders for installation in cabinets. I make them out of 2 X 2 that I slot using a table saw and I attach the PCBs to mdf sheets. The pictures with the boards positioned horizontal were my first versions. I can fit 6 to 8 boards in the cabinet depending upon the...

What is the issue with replacing the backdoor?

Does anyone know if there is a replacement flyback for a Sanwa PM1718 19" monitor? Thanks.