Recent content by dextrolite

I have a Gauntlet 1 in my repair pile. There were no notes with it as to what might be wrong. I have a working machine that I am able to test the board in that has good voltage. I tested all of the 1420 ram and the two 6116s - they all tested fine. ( For completeness while I had the chip...

I have a Taito Space Invaders Trimline that only shows a single column of 4 aliens when it turns on. After 10 or 20 seconds or so, the picture blinks off and then comes back on a few seconds later. This is a three pcb stack board set, and it has the tv0h - tv04 roms installed. I did verify...

Check with Rowe/AMI. They are offering software that will run on those machines.

after a few minutes it starts making the attract sound. I can coin it up, but as soon as I press either start button, it dies.

Im working on a Gunblade NY (projector monitor cabinet) for a friend. The game doesn't appear to start at all. The monitor portion is shot, which I'm not too concerned about for now. But I'm not getting any sound. I opened the computer cage to check the indicator leds. The two green lights...

Looking for a replacement dome for a 1966 Sega Basketball. Thanks

Either no responses from people, or they don't have the parts so far. And the guy on ebay said he would take pics, but hasn't sent any. Got a few more emails out so, we shall see.

I emailed pinball resource. He doesn't have the part I need. I think I can repair my contact plate. The problem at this point is that I don't have the insulators installed in the wiper assembly, as I can't figure out where they are supposed to go.

I don't have the assembly pulled out of the cabinet at the moment, so I apologize for the crappy pictures. http://i49.tinypic.com/2nizx5.jpg http://i49.tinypic.com/2u71v6h.jpg

This is the assembly that I'm having problems with. Shot count contact plate Plate # 373-2510-b finger # 379-2529. The plastic rods that held the fingers in the correct order were damaged. When I went to work on it the fingers came apart. I have them back in place as well as I could going...

Hello, I'm working on a Chicago Coin Funland Rifle. You can coin the game up and it will start, but it doesn't keep track of the number of shots fired. The assembly in the top that count fell apart and I don't think it got reassembled correctly. I have somewhat of a manual for it but it...