Recent content by darthbob1425

Thanks I would be up for buying a couple off you if thats ok. Can you provide them pre-programmed as I've been through the supported list on my writers and they're not supported. Cheers Rob

I have run the board through my jamma cab with an adaptor. The red is completley absent. It looks like the chip will be the way to go. Cheers Rob

My track and field is working fine apart from a ditinct lack of red. I have traced the red line back from the edge connector to a PROM marked 361B16 (TBP18S030N) and you can see a very faint cross on the top. The previous owner was an arcade operator so I am assuming at this stage that this...

I have a 6-slot MVS on a 19" monitor. I do not recognise the chasis. Started it up for the first time in a few weeks and the picture is overly bright. It will adjust on the flyback but as the picture was fine before I am worried that somwthing is about to go flooey. If possible I was to...

I take it that there are no major adjustments just link the RGB, sync and ground from my loom to the correct input pins for the monitor?

I have most of my test bench set up completed and now need to source a small monitor. I have a 14" Hantarex Polo chasis but no tube. (If anyone has one for sale PM me) The other thought I had was could I use an old computer monitor. I have old Microvitec BBC, Amstard 664 and C64 monitor in my...

I need a tube for the above. Ideally in the UK, nearer Birmingham the better Rob

I have a set of Kick and Kick boards out of a water damaged cab. I didn't realise that it was Cd-rom based. Is there anything else I can run on this board??? Rob

Thanks for the reply. The main problem with you idea I have is my knowledge is limited. My easiest option would be a direct replacement if can can get an ID. Rob

I have come across a Jaleco Formation Z board but this is identical to the AEROBOTO board. Overall its looks in good nick apart from a chip smack in the middle of the PCB at 6J. Its a 24 pin chip but the ID has been scrubbed. Is this a custom chip or not? If it is can anyone point me in the...

AEROBOTO Chip Id Thanks Brent for the alt board name. I don't know how I missed it on klov. I've looked at a pic on Crazy Kong and it is the same board and layout. You can see the details on the chip but not clear enough to read. Has anyone got an aeroboto board who can ID the chip at J6...

If no one has any suggestions I suppose I can try jumping a wire between the broken leg and the solder point. Cheers Rob

After a year or so out I have finally escaped back to the garage to try and fix up my collection. I have come across a Jaleco Formation Z board. Overall its looks in good nick apart from a chip smack in the middle of the PCB at 6J. Its a 24 pin chip but the ID has been scrubbed. Is this a...

I thought I had a bargin phoenix board off e-bay but on arrival I checked all the proms and it tested as Plieades. I contacted the seller who claims that a rom swap is possible to convert it to Phoenix. Can anyone confirm this is possible???? Rob

Finally found a pinout for Galaxians on an MC-1 board. http://www.arcades.plus.com/pinouts.htm Now all I have to do is wire up a loom and give it a go. I think Cheers Rob