Recent content by Danomite

I want to replace this old bezel. Looking for any advice/tips. I’m leaning toward making one out of some black poster board. Also, was the original plexiglass clear or tinted?

Thanks for the heads up. I’m going to order some of these, there’s also two other pots with a “32” and the other has a “54”. They all look the same (same style) are these available as well?

Can anyone tell me where I can get these pots? Only marking on them is 53. Thanks. From a KT2001SF

I have a NOS Kortek 19” monitor I believe to be from around 1999 -2001. I can’t get it to stabilize V hold. It will lock in but then soon after it starts to slowly drift. I’m reading that I should start with caps and the pots but since this monitor has never been used would you expect bad...

It came from a ms Pac-Man Cocktail that was made in the early 2000s. The only thing original is the pcb. The tube was manufactured in 7/2000. It used to work fine, I kept the original ms Pac-Man board inside and added an adapter and a 60 in 1. That set up worked also. I’m assuming the...

I have a early 2000s 19” Sony Trinitron tube with a Sharp Image chassis. The game this was in got knocked pretty good one day and the screen turned white. I wasn’t able to make it any better with adjustments so I sent the chassis in to check if it needed to be repaired. I was told the chassis...

Good Stuff.. thanks again..

Ok thanks!

The new PS is the common Suzo Happ that looks similar to this one, not the big box style. It has GND and FG. Do I connect the 0V wires to GND and the green wires to FG?

Kinda hard to get a good pic I think this one shows it

I have a Phoenix I want to replace the PS. The one I want to replace has a couple of wires hooked up to a 0 volt terminal.. The replacement does not have a zero volt terminal. Can I ground these wires? What’s the purpose of zero volts? Thanks..

This looks promising. Think it will work? https://www.ebay.com/itm/MZ72-MZ73-CRT-Tube-PTC-Degaussing-THERMISTOR-IBM-Posistor-fot-TV-and-Monitor/252654525450?ssPageName=STRK%3AMEBIDX%3AIT&var=551574047559&_trksid=p2060353.m1438.l2649

Should there be 2 of the little round things? I only found on in the box. Also, what does PTC stand for?

I'm not sure what this component is and whether or not it's possible to obtain another. Its from a Sharp Image 27 inch chassis. There's a picture of another SI chassis that shows it intact with markings FCDC 09M270. Another picture of the designation marking PTC801 J801 and a picture of the...

Not sure what this is called I peeled the indian casino sticker off.. I want to make it look better.. what do you suggest..?