Recent content by cdjump

  1. cdjump

    Atari Logo Joystick Rebuild Kits

    I'm fairly sure this is Ram Controls parts. No one should ever buy this crap. @Tombo @mclemore
  2. cdjump

    Journey ROM Hack: KLOV Edition?

    journey has an ini file in the above Graphics editor, so it should be doable.
  3. cdjump

    What do you do with your most temperamental games?

    Schrodinger's video arcade game.
  4. cdjump

    In search of Golden Tee Fore 2005 Wiring advice

    A quick search says that the reds are +5v, the blacks are ground, and the 1 yellow is +12v.
  5. cdjump

    Tron3 (aka, Tron: Ares) gets the green light.

    Its Rotten Tomatoes scores are 60% right now, which is in line with the original, and better than Legacy. https://screenrant.com/tron-ares-rotten-tomatoes-score-debut/
  6. cdjump

    Japanese Arcade Warning Signage.

    Bitd, i'd occasionally end up with extra tokens that i didn't have time to spend, or didn't like the games, whatever. I would take them with me when i went to an arcade, buy some tokens of theirs, then match my leftovers that were the same size and use them all. Wish i still had some of those...
  7. cdjump

    Keep Atari Xevious Or Exidy Mouse Trap?

    Unhook the speaker and keep the Xevious.
  8. cdjump

    CRT replacements for the future?

    I had a slightly earlier version of that tv. It had dvi and not hdmi inputs, iirc, it was 720p, talk about one heavy tv. Took 2 full grown men to move it.
  9. cdjump

    Okay, Atari dorks! NAME THAT CAB!

    It looks like to me the Crystal Castles conversion kit included a new control panel with the trackball hole already in it - https://arcarc.xmission.com/PDF_Arcade_Atari_Kee/Crystal_Castles/Crystal_Castles_TM-265_1st_Printing_Conversion_Manual.pdf Page 28 references installing the trackball...
  10. cdjump

    Okay, Atari dorks! NAME THAT CAB!

    Probably a Kangaroo or Arabian converted to Crystal Castles, then to Tetris.
  11. cdjump

    Which games are better as a cocktail?

    Demo Derby. Pretty much any game that allows you to play head to head with more than 2 players.
  12. cdjump

    MCR Troubleshooting.

    Did you replace the filter caps on the video pcb? Every so often, i see people do that, and bridge the +5 and gnd together. Could also be a failing 10uF tantalum cap. I've only seen one or two of them fail at 5v though. The ones that see 12v fail all the time though. All of the 24 pin...
  13. cdjump

    MCR Troubleshooting.

    No, i had someone send me a 90412 one time that they rotated it 90°, and that was blowing fuses, i think it was on the suitcase, though, its been a while back. I thought that if its working fine in Tron, though, that's not the issue. I'm going to guess that it'll be fine with a 1 amp slo-blo.
  14. cdjump

    MCR Troubleshooting.

    What size fuse are you using? Also did you by chance replace the 9 pin molex on the 90412? edit - i guess not, if it works in a Tron. I'd try a 1 amp fuse. SH draws more current than Tron does, by a good bit. I think there was a service bulletin about it.
  15. cdjump

    Aladdin's Castle Memo

    None of it makes any sense. If the resistor wasn't over wattaged at 1.5 ohm, a single 3 ohm would be more than adequate. Even if it was, swapping to a 3 ohm (same wattage) resistor should be fine unless the resistor was more than half underwattaged. The simple solution was just to use a...
Back
Top Bottom