Recent content by catnip

Frank, Thanks for the suggestions. I'll try them out this weekend. I also just rec'd a rebuild kit for the AR II board from Bob Roberts...I thought my issue might be found there. I'll post progress. al

I was trying out a new board in my Centipede and accidentally hit the interlock switch and turned the unit on before I had the edge connectors in place. Then came the electrical snap from the board and the F5 Slow Blow blew. Now I have a board that only produces a blue screen and a fuse block...

Tom, Thanks for your help and the wiring diagram. It seems that my monitor problem was a monitor problem, but was also a board problem, which made the diagnosis more difficult. I now have a refurbished board and everything is working fine, including the new monitor. Thanks Again, Al

Tom, Thanks for the helpful information. It confirmed that I was hooking everything up correctly. The only thing I can't hook up is the yellow because that wire is cut short at both ends. What I get when hooking up as you described is a mostly white screen with verticle black lines running up...

Well, I'm not sure. What I've got is this. On the 6 pin connector I've got Red Green Blue and a bare ground. On the 3 pin I've got black gray and purple & Brown on the 3rd pin. The white yellow and orange are cut at both ends and don't appear to have ever been used.

The plug and play didn't work....why didn't that surprise me. The 6 prong plug has red, green, blue and a ground wire which I just found doesn't actually ground to the board like I assume it should. The 3 prong has black, gray and a brown & purple on the third pin. The white, yellow and orange...

I just purchased a Vision Pro 19" to replace the original (dead) G07 CBO monitor in my TRON. The directions are more or less schematics only. My question is, should the G07 plugs plug right up to this monitor (they will) or should the Vision Pro plug be used and the harness be spliced? If the...