Recent content by boy141

  1. WTB: BOXER schematics or PCB

    I am hoping resetting the dumb game fixes my issue. Credits the game, pushes the start button - nothing. worked and then nothing. i hope it is not an electrical issue.
  2. K7000 P447 is this veritical collapse?

    We are back. I really remember why I hate working on chassis. Less of a headache to swap out. I replaced the flyback with one from arcadepartsandrepair. The B+ still reads 170v. I unsolder D10, and the tube does NOT come on. Solder D10 back in circuit. Measured cathode side of D12 -...
  3. K7000 P447 is this veritical collapse?

    Tested Pins on the yoke header pinpads test fine using continuity. Followed green and yellow wires to other side of the board. did continuity test - works. didn't get a chance to buy parts for the lightbulb test. something to do tomorrow between meetings .
  4. K7000 P447 is this veritical collapse?

    I wonder that myself. I just wish there was a way to test these flybacks without sacrificing HOTs. But when i power on the device, no static. The B+ is way too high.
  5. K7000 P447 is this veritical collapse?

    but now I don't have neckglow after switching out D18. I'm going to do the lightbulb test today to see if I have good power. See if the issue is the power side or the horizontal output side. Be a good video for @zenomorp on his Youtube saying "This chassis had some work done to it. It's been...
  6. K7000 P447 is this veritical collapse?

    FYI D13 is reading .44 in diode mode and not open.
  7. K7000 P447 is this veritical collapse?

    Hey Mecha. Looking back at my notes - Reflowed yoke connectors Reflowed header pins Reflowed vPos pot changed out D18. D18 black band is facing away from the metal heatsink. D19, D20, D21, D22, D23, D24 not open. Reads between 46. and .52 in diode mode. C38 isn't open. Critical safety cap...
  8. K7000 P447 is this veritical collapse?

    Update Reflowed Yoke connectors and headers. Replaced D18 cause it looked terrible. NO NECKGLOW. Fuse isn't blown. B+ from the blue wire side is 170V. B+ is measuring 200 ohms
  9. K7000 P447 is this veritical collapse?

    19" K7000 Initially the tube was not displaying anything. Saw a few busted caps. Did a capkit. Tiny cracks on the front of the flyback for it's age. No arcing. Put the game back into the arcade. 3 days later this mess. On the verge of Vertical Collapse? Switchout IC3?
  10. What are my choices for a claw machine that fits my needs?

    UGHHGHGHGAHGLKDGDGJKDLFJALS I trashed two of those months ago
  11. Looking to have Bally boards rebuilt, who fixes these?

    Do the ground mod for the driver board as well and get the rectifier board upgrade plus repin the connectors and you'll be set. Trash the MPU unless you think it works. I have 20ish ballys/sterns and that's what I do for all of them. Transistors is usually what goes bad on a light driver board.
  12. Looking to have Bally boards rebuilt, who fixes these?

    Hey John. What happens when you turn on the game? The driver board usually gets rebuilt as well as the rectifer board.
Back
Top Bottom