Are you sure the doors will not work? Many times the doors are the same, they are just put into single vs over/under frames. Hinges employ a set of 4 screws to hold the door in the frame.
Yea, searches have revealed your distaste. LOL
I have no want for me, just working with a friend and don't want to donate half my life to the effort that's all.
More pics:
Have a friend for whom I fix up games he's looking for. It's a compensated gig but I don't charge anywhere near retail with this individual for various reasons. He's asked about a Shuffle Alley/Puck bowler and I knew of this one sitting in a shed for at least 28 yrs now. Pics are below...
I think some things are getting lost in translation here.
19K4915 and 25K5515 use the STR380 (123v) voltage regulators. IIRC it will actually RUN with either because the spec on the HV shutdown is sufficiently over normal operation range to avoid false triggers.
I have a...
So the problems you are describing are most often caused by bad solder joints. It's not just knee jerk, that most likely IS the issue here. It just happens to also be good advice in general because it's a frequent issue - these chassis ran long hours for many years and the solder around...
Reading through your problem description I'd say it sounds like the chassis has cold solder joints and needs an inspection and reflow. If you haven't capped the chassis I suggest you do that at the same time.
@mneubey seems to be able to crank these out with a little help on scans and verification from members.. Maybe he can help here?
https://forums.arcade-museum.com/threads/arcade-stencils-now-available-arcadestencils-com.543977