Recent content by azbolick

I picked this up to go in my Neo Geo Cab. The guy I got it from is great and we do business all the time. Anyhoo, I got it hooked up and dialed in and IT IS FREAKING DARK. It has had a cap kit. Anyone know? Monitors arent my specialty. I've also been reading that these are a pain to get...

Thanks! I have a big pair of those up to the elbow rubber morticians gloves I use until I'm sure I wont get the business end of 20,000 Volts.LOL. Seriously, that sounds like I might just want to live with it. I have a strange habbit of fixing something so good it wont work anymore

I just capped and replaced the H. Width Coil on a K4600. I have it dialed in but it has a slight counter-clockwise rotation to the image on the tube. How does one go about adjusting that? I cant figure that one out. Thanks!

I had the EXACT same problem and had to reflow the solder to the red pin out on the monitor chassis. It took me a while to figure out but now it is perfect.

I had the same issue on my Countdown. A few of the new rubbers are closing the blade contacts. I bet if you take off a few the machine will start without a problem.

Triple Thick from Krylon will prevent it from getting worse. Make sure you mask off any clear scoring windows as this will 'fog' them up. I use about a can on each of my backglasses. I also buy mine at K-Mart. Some places charge double what the Big K does.

Every now and then when a ball drains from the playfield, it will be stuck in the trough under the playfield. If you open the coindoor and give the ball a push, the game will continue. Could this be a dirty opto or what? Thanks!

Re: Bone Busters!! Solved: Cold solder joints on the underside of the game rom daughterboard. Wow. I'm spent.

Hold on, I'm still reading the long, drawn out item description on the auction. It looks good! Too bad you cant get a good look at the playfield.

Bone Busters!! I'm almost there. I've narrowed it down to the MPU. I re-seated all of the socketed chips on the board and the game fired up and played. I played for a few and then powered it off again and on powerup, it wont start... All my fuses are good and tested. I ordered a CPU and a...

Count-Down I'm selling this and was just wondering about the display issues. The first digit on the Plyr 2 and 4 wont light up. I pulled P2, cleaned the board and contacts. I seem to remember someone asking the same thing but I couldnt find it. Oh, buy my pin!! All proceeds go towards...

Bone Busters: AT WITS END!!! I'm at a total loss now. I've gone through Clay's and Kirby's guides but I think what I'm running into misght actually be a power supply issue. Since my game is a 80b, they really dont cover it. The only thing I can do is measure the voltage on the CAP just to...

I have the NOS Manual with all schematics and can pdf and mail whatever you need. Really, I've spent a lot of time on this game but really, I am terrible at the electronics side of it. I appreciate whatever help I can get on this.

So I'm pluggin away at this. All Tilt/Slams have been disconnected. I have removed the board, cleaned all contacts, checked all solders, etc and still I get 30-40 plays out of it and then it freaks out. Someone please help me out here cause I'm going nuts!! I even unsoldered one end of a...

Okay, I've poured over everything on the net about this and my machine seems to not be the norm. This is the Bone Busters I picked up last month. Anyway, the tilt switch board mod doesnt apply to mine. When I bridged the two points, the "Tilt Switch Closed" error came on. Mine has to stay...