Recent content by asteroids79

i'm completly missing this. i double checked the scematics, but i cannot find the 6.3 volt lead for the heater. can you dummy it down for me? thanks again. i am getting 6.82 AC volts to the coin door light. learn something new everyday, i thought that was DC voltage. thanks.

thans again, guys...will reflow the 3 monitor boards and will update.

Found the monitor manual, will be looking over that. thanks. http://arcarc.xmission.com/PDF_Monitors/Atari%20Monitor%20TM-146%20Issue%202%20Electrohome%20G05%20Monochrome%20XY.pdf Ah, page 30 of the op manual has the power brick diagram, i missed that. All fuses on the power brick are good...

no light in the coin door, and the socket is getting nothing on my voltmeter. fuses check out fine, though. i hate to ask, but which one is F6 (my power supply is not marked at all).

very cool, thank you. i'm betting on the high voltage failure as well. should i get the transistors on the chassis changed out as well?

ok, if i pull the video input on the deflection board, then power the game on, the spot killer LED comes on. when that video input is plugged in, and the game powered on, the spot killer is off.

I never said i have no sound? it plays fine blind. the sound works, all buttons work. As for the link, the first one ended up with the guy having a dead board, which i don't think i have...i measured the X and Y inputs, and they were reading correct. Voltages read correctly from the regulator...

just searched the forum, with no luck, where can i find the serial number on this game, if the label on the back is gone? thanks. none on the power supply, and i don't see one on the monitor chassis or the pcb.

GO5-801. 2 seperate labels attached to the chassis. yes, game plays fine, just blind. it's set on free play. i get typical noise from the monitor when the game is powered on. no neck glow, no picture.

owl eye coin door, yes. serial number, cannot find (no labels on back of cab, no serial number on PCB or audio regulator board). bezel writing is white. thanks.

i'd like to do it myself, but no experience/zilch with vector monitors. does bob roberts sell a rebuild kit, or do i buy the individual components (1 which he is out of stock on)? all chassis fuses are good, including the one under the high voltage cover/section. no neck glow (is it noticeable...

Thank you. How much should i expect to spend to have somone do a rebuild to my chassis? Or do it myself? Since i can source parts from bob roberts.

Recently picked up an asteroids game. it powers up, and the game will play blind. no glow in the monitor neck. it's a GO5-801. Big blue has been changed out, no change. 33.5 volts going to the GO5801(6 pin molex) If i run a dedicated 120volt line with a transformer to a swapped monitor, would...