Recent content by ArcadeGeek

Still available. Payment has yet to come though from an interested party.

Very nice and clean fully working Nintendo PC-10 Countertop. It has custom side art and new overlay and custom bezel. Games listed in picture.

Fully working Nintendo Red Tent. Has some custom overlays. It had some bad buttons and I could not find originals so it has micro switch buttons. Super Mario Brothers and RBI baseball. I have added casters for easier moving as well.

Bumping to top. Thanks.

Atari Road Runners Control Panel or Hall Effect Joystick I am working on a Road Runners kit for my System 1. I have the PCB but am looking for the CP, Harness and Marquee or at least the joystick. Let me know if you have any of these. Thanks.

Sounds awesome. I’m in for one

Bump to the top.

I am looking for a working Atari Football. Let me know if you have one you would be interested in selling.

I have a Vision Pro 2902 that has a 5 pin power connector. I am wondering if anyone has a cord or the pin out so I can get a replacement. Here is a picture for reference. The Suzo site has schematics but it shows more standard 3 pin connector at W802.

I have been working on a Nintendo Space fever monitor restore and I am in need of a chassis or complete monitor. Let me know if you have one. Doesn't necessary need to be working. The monitor I have has a horizontal position issue and I would like to do some replacement testing.

Anyone have a source for a linearity coil. It’s from a Sanyo 14 AZW. Only marking is 290B.

My thoughts as well. Now if I can just find a source for a replacement.

Thanks for that info! Do you happen to know if a failure of this component would cause the horizontal screen position to be off? Is there a specification I can look for and is there a possible replacement source?

Anyone know what the circled component is? Should be a horizontal width coil based on schematics for a different versions of the chassis that I could find but I have never seen one that looks like this.

Good info. I did try the j11 jumper as well. It was cut but I attached it as well with little to no difference. My chassis sounds like your original one. I also do not have the VR452 but there is an unmarked VR Pot that appears to be the same function as it is a 500k VR and it does...