I made up a couple of sets of wooden T-Nut blocks to repair my Sinistar leg levelers. The blocks where the t nuts fit in were all beat up and caused the levelers to be very loose on my Sinistar. I made an extra set for my Joust but it turns out that I did not need to as the Joust was fine. I...
Hey guys! I have been on this forum for quite some time for arcade machines. I am brand new to pinballs and have no clue how to purchase one. I love Pulp Fiction and would love to buy the Bad Mother Flipper edition. I just need some purchase advise. Who are reputable dealers? Is there anyone...
I picked up a really nice Sinistar this past summer. Surprisingly, the monitor bezel is in super nice shape. There is only one small spot (maybe about 1/2 inch) of light blue that needs to be touched up on the left side. I attached a picture to this thread. Anyone know of a color match or a...
I made a wiring harness that connects a Williams 49 Way joystick to a JROK board. It works great. I had it in my Multi Williams until I found a dedicated Sinistar. Both proper connectors are there. You just need to hook the two loose wires to 5V (orange wire) and ground (spade connector). Once...