Recent content by anks

Im still looking for someone that could help

Ive got a skins game that was running the tornament version but yesterday the hard drive failed. Ive borrows a hard drive from a friend that has the non tornament version and the game boots fine and could image this but this version of the game isnt as fun after having the other version. Ive try...

Ive got a kortek chassis that is not powering on that I tryed fixing a long time ago. The monitor had a fussy picture and then would not turn on at all. After replacing a few caps I got it to start again but it died a hour or so later. Anyway cut along story short I pulled some caps and was...

Re: WTD Dunk Shot pcb working or not I may want the trackballs if I manage to get a working board

Re: WTD Dunk Shot pcb working or not Id have one off you if I wasnt in the uk. Just out of curiosity how much do you think shiping to the uk would be.

You can do Ive done it. if you want more help i think parris on arcadeotaku dot com also did this recently. kris

WTD Dunk Shot pcb working or not Hi im looking for a Sega system 16b dunk shot pcb working or not. Kris

Hi thanks for the link. Found a manual for indy 500 which might help(just printing it) If anyone else has any ideas let me know Cheers

I was hoping someone can help me. Im Trying to find a pinout for racing games on Model 2B CRX. I was told that there is a away to use generic wheel providing the pots are 5K. The only problem is I cant find were to conect the pots on the filter board. Im not bothered about the feedback has im...

Has anyone got a picture of the underside of the K7000A chassis. This would be a great help.

well ive just been let into a secret. Someone has taken the wells gardner factory mods off the bottom of the chassis. Im also under the impression that these are what made the difference between the 19" and 25" monitors(maybe wrong about that). Cheers for the ideas

A little update to this. Ive just had another check and the resistor is now not only hot but glowing. Could this have anything todo with the horizontal width circuit.

I was trying to alter the width on my K7000A chassis by changing the value of the cap at C38 and noticed that R97 was getting really hot. Also Ive just checked the B+ and im getting 127.5v which is not too much over the 123V that its suppose to be. Ive tryed altering VR8 but this dosnt seem to...

looking at bob roberts width cap kit the ones he provides are all around that. I was just wondering what type of cap can be used in this spot. * Width Cap Kit * F104K 250V * F104JK 250V (Heavier) * F224K 250V * F224K 630V * F334K 250V * F.47K 250V (F474K) *...

Was just wondering what type of cap can the width cap be replaced with. Im from the uk so getting stuff from bob roberts takes quite a while. Ive got some caps the look like the right sort of caps but they are blue. The markings on the blue ones are PMH .33J 200V 9721 , PMH .56J 250V 9725 and...