Recent content by alexanr1

Are you sure you don't need 161 bulbs? They are a 14volt coin door bulbs.

Thx. Mine is the wood cabinet not the plastic one. Never liked the plastic one personally. I don't have any of the common kits either. All are game specific. I was hoping to get $1000 for the whole set. That's to all for the feedback. As soon as I get it out into the garage, I will list it.

Thanks for the couple references. Trying to get a rough value from folks. Sounds like its not something easily priced out.

Never seen a cocktail Sente. Would think they only made a few games for it since the control panel would be tough for a car game or even a trackball game. I am hoping that having eight different games might up the value. You ar just around the corner from me I see. I am in Pickerington.

I am considering selling my Bally Sente SAC-1 machine and the SAC kits. In general, I know this is not a sought after machine. What I am hoping is the collection of games I have makes it worth more. I would appreciate any feedback on the value. The cabinet is an original Bally Sente cabinet...

I have decided to pass, For now. Getting anyone to look at the PCB for omega race is next to impossible. I called around. I also have a recent DK project. I need to get my neo geo out of the basement and to the garage before I even consider swapping. I have some popular games for the...

Is the sanyo still available? Looking to replace my Donkey Kong monitor. Assuming its an exact swap for it. Would you accept Paypal for payment?

Two are on ebay. http://www.ebay.com/itm/Bally-Pinball-AS-2518-32-Sound-Board-Guaranteed-Works-100-/310613373488?pt=LH_DefaultDomain_0&hash=item4851fff230 http://www.ebay.com/itm/Bally-AS-2518-32-50-Sound-board-KISS-PLAYBOY-Works-100-/300862894382?pt=LH_DefaultDomain_0&hash=item460cd3712e

Didn't think Schaffer did anything with monitors anymore. Will have to call them. I just want a cap kit done to my monitor.

I am looking for someone as well local to Columbus. Can't believe as big of a city as Columbus, there is no one in town. donkey Kong monitor

Will probably take you up on that. Need to figure out how to get the board out. I am use to everything having molex connectors on pins. Assuming I can pull out the main board and send it to you. Any removal advice is appreciated. Thx.

Here is a screen shot. The color is great and the image is clear, it just cuts off on the left. As I posted above, I found, on the CPU, vertical picture controls. It helped a little, but it still cuts off. I have never done a cap kit, and I am a little nervous doing it with the high voltage...

I think you are right. I did find that there are image controls on the actual CPU board, which surprised me. Will go grab a pick and post it ASAP. Thx!

Just to clarify, does anyone have a schematic pointing out all of the pot's on this monitor. I am guessing there are some on the chassis. Nothing is labeled in my machine.

I just bought an original Donkey Kong. It has a Sanyo monitor. The left side of the monitor is cutting off the image. I don't see any pot on the monitor to adjust the screen position. Is anyone familiar with this monitor to point me to the pot that adjusts this? Thanks in advance, - Rich