Recent content by actionpaintball

Area 51 Maximum Force Jamma Board, working condition please

Still have it?

I replaced the few suspect chips and ended up finding a replacement board in Ireland. All is well.

I used the machine again this weekend. Same scenario...had to leave it plugged in overnight before the calibration memory would be accepted.

https://postimg.org/image/jxljkobgd/ https://postimg.org/image/f2mil94fp/ https://postimg.org/image/57jp6pgg7/

I am losing 12 volts on two legs of the power supply when the game is turned on. I was measuring the power supply with everything disconnected but as soon as there is a load the 12v drop to 5 to 8volts.

I am on it, thanks for the info

Man...this machine is still sitting and I cannot figure it out. Does anyone have a 6300 series board that they would out my boards on? Both my power supplies seem to be working.

Thanks for staying with me on this. Yes, it just started doing this, it would hold the calibration before. I will get some better pics tonight. I have owned it for 4 or 5 years.

Ok....what about these big guys on the back?

Nothing under the EEPROM. see image here: https://i.image.org/25fc110dcf.jpg

Thanks, I shrunk it down but will try to hotlink a higher res pic tonight and I will check out the caps.

Here is a shot of the board

I have a nice older snap on balancer I use for personal use in my shop. It's always worked great and still does, except recently it started losing the calibration memory when unplugged for longer than a few days. I can get around this by plugging it back it for 24 hours and then going through...

Pics......