Looking better inside, still need to do more wire clean up, and replace the Power supply back to the original style. I made 2 cotton rags a dark shad
Finished soldering up the wires that were electrical taped, and re-mounted the Monitors Remote board to the control panel box.
Looking better inside, still need to do more wire clean up, and replace the Power supply back to the original style. I made 2 cotton rags a dark shad
Monitor harness all repaired.
My soldering skills. (i'm not the best but i think i do alright :D )
My Bob Roberts Crimp tool, New Connectors from Riptor, and my crimping skills.
MK4 Panel somewhat installed. (still need to install molex's on jamma harness and decide if i'm going to install a hinge or install the MK1 Maintenanc
Original MK1 Ice Water Camo CP (this was definitely a golden tee at one point, i found a control panel sticker circle that was cut out and it had gras
Broodwich

Looking better inside, still need to do more wire clean up, and replace the Power supply back to the original style. I made 2 cotton rags a dark shad

There are no comments to display.

Media information

Album
MK Cab Restore
Added by
Broodwich
Date added
View count
70
Comment count
0
Rating
0.00 star(s) 0 ratings

Share this media

Back
Top Bottom